What are the construction processes of epoxy floor paint?
The information comes from:the Internet posted on:2021-12-28
The epoxy floor paint process package is as follows:
1. The contracting party shall set up a template for the periphery of the art floor according to the drawings, and the height of the standing mold shall be level with the design elevation (no need to reserve the height like laying floor tiles), and place the well frame or bury the underground pipeline.
2. The contracting party shall provide on-site concrete paving, leveling the slope, muha leveling, and sufficient mortar. It is strictly forbidden to add water to the paved concrete, keep the concrete water-cement ratio and slump consistent, and pour in order in sequence After paving the concrete, hand it over to the construction staff of Yimei Color Stone Art Floor.
3. When there is no obvious moisture on the surface of the concrete, the construction personnel shall evenly spread the colored reinforcing material on the surface of the concrete. The spreading material shall be evenly covered and the thickness of the spreading shall be consistent as much as possible. After the reinforced material absorbs moisture and gets wet, the construction personnel use the art floor spatula to collect light on the art floor surface. The light-receiving requirement is flat, no traces of the spatula, and the light-receiving speed is fast.
4. When the color of the epoxy floor paint becomes dark and the floor surface is not hardened, evenly spread the color release powder. The release powder should be thin and uniform, and it should be completely covered.
5. After confirming the direction of the mold discharge, arrange the art floor impression molds closely according to certain rules, and the splicing requirements are tight, and no gaps are allowed. At the same time, the mold placement must be accurate once, and the mold cannot be retryed repeatedly. Place and lift the mold should also rise and fall vertically without dragging the mold.
6. According to the softness and hardness of concrete, skilled technicians can well master the strength of the press mold and the depth of the embossing. The softer parts of the concrete can be stepped on, and the harder parts should be used in combination with a rammer to imprint. The lines that come out can achieve uniform lines and consistent depth.
7. Seal the area where the texture embossing is completed to prevent irreparable persons or vehicles from entering and causing irreparable damage. Epoxy floor paint should be closed for at least 1 day in summer and at least 3 days in winter before it is feasible, but vehicles should be prohibited The passage. Washing is usually done after the texture imprinting of the artistic floor engineering is completed, because the surface of the unwashed artistic floor is evenly covered by the release powder, which can effectively prevent the artistic floor from being stained with grout or other difficult-to-clean stains .
8. Rinse the mold release powder on the surface of the art floor with water, washing powder or detergent, and a floor brush. After the scouring, about 15% of the mold release powder on the surface of the art floor can not be cleaned. The mold powder has a very good enhancement effect to increase the texture effect and color gradation of the artistic floor when the protective agent is finally applied.
9. After the washed floor is completely dry, use a common paint wool roller dipped in the art floor protective agent to coat it on the surface of the art floor. The art floor is required to be coated evenly and fully covered. Standard The dosage is 0.2 kg per square meter. The machine can also be used to spray artistic floor protective agent. The art floor protective agent can seal the pores of the concrete surface, and at the same time make the art floor show a natural texture and color, and can effectively prevent the ground from being polluted.
